![]() ![]() My suggestion is, use an online calculator to get the answer. It does depend on your listening habit, speaker sensitivity, and distance. You also ask about whether the 4800 can drive the R6 Meta, and I thought that was covered but may be not, so I will say this again, almost any AVRs can drive 4 ohm speakers that often has dips to 3 ohms or even lower. RCA-XLR is of course not the same as XLR to XLR but it is supposely still a little better than RCA-RCA, based on Hypex articles on this topic. Notes, cautions, and warningsNOTE: A NOTE indicates important information that helps you make better use of your product. I would recommend using RCA-XLR, but if you try RCA and do not hear hiss and hum, then save your money. Dell G3 15 3500Setup and SpecificationsRegulatory Model: P89FRegulatory Type: P89F002August 2021Rev. ![]() in recording devices it is shown as microphone. in recording devices, it was also recognized as USB device.With the 3.5mm headset, it is recognized as speakers. ![]() When I plug the USB in, windows recognized the headset as USB device and not headset. No extra conversion as long as you do the above. both of my headsets are having the same problem. If you use the analog inputs, in direct or pure direct mode then ys, the Denon will work as a preamp in that case, assuming you are using external power amp obviously. If your external dac has better specs, then it is better to use it with the Denon's analog inputs, but only if you use direct or pure direct mode, otherwise the signal will be routed through the AVR's ADC and DAC anyway. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |